Protocol for Making a 4% Formaldehyde Solution in PBS

The vast majority of IHC/ICC procedures employ fixation of tissues and cells using formaldehyde-based fixatives. The protocol below describes the technique for generating a 4% formaldehyde solution in PBS. The most effective fixative must be determined experimentally.

Caution: Formaldehyde is toxic. Please read the MSDS before working with this chemical. Gloves and safety glasses should be worn and solutions made inside a fume hood.

Please read the protocol in its entirety before starting.

Download Protocol PDF

Reagents Required

• Deionized H₂O
• HCl (Dilute)
• NaOH (1 N)
• Paraformaldehyde powder
• 1X PBS: 0.145 M NaCl, 0.0027 M KCl, 0.0081 M Na₂HPO₄, 0.0015 M KH₂PO₄, pH 7.4

Materials

• Filter units
• Glassware and stir bar (dedicated for formaldehyde solution)
• Gloves and eye protection
• Hot plate with magnetic stirrer
• Thermometer
• Ventilated hood

Procedure

1. For 1 L of 4% Formaldehyde, add 800 mL of 1X PBS to a glass beaker on a stir plate in a ventilated hood. Heat while stirring to approximately 60 °C. Take care that the solution does not boil.
2. Add 40 g of paraformaldehyde powder to the heated PBS solution.
3. The powder will not immediately dissolve into solution. Slowly raise the pH by adding 1 N NaOH dropwise from a pipette until the solution clears.
4. Once the paraformaldehyde is dissolved, the solution should be cooled and filtered.
5. Adjust the volume of the solution to 1 L with 1X PBS.
6. Recheck the pH, and adjust it with small amounts of dilute HCl to approximately 6.9.
7. The solution can be aliquoted and frozen or stored at 2-8 °C for up to one month.

The difference between paraformaldehyde, formaldehyde, and formalin

Paraformaldehyde (chemical name is polyoxymethylene) is a powder of polymerized formaldehyde that by itself cannot fix tissues. To be usable as a tissue fixative, paraformaldehyde has to be dissolved in hot water to become a formaldehyde solution. Formalin is a saturated formaldehyde solution in water (37% by weight, 40% by volume) containing 10-15% methanol. Methanol is added to slow down the polymerization to formaldehyde, which reduces the fixing power of formalin. Formalin can also be made in an alcohol-free form from powdered paraformaldehyde.