You are here

Home » Resources » Protocols » Protocol for the Preparation and Chromogenic IHC Staining of Paraffin-embedded Tissue Sections

Protocol for the Preparation and Chromogenic IHC Staining of Paraffin-embedded Tissue Sections

Protocol for the Preparation and Chromogenic IHC Staining of Paraffin-embedded Tissue Sections
View Graphic Protocol

The following immunohistochemistry (IHC) protocol has been developed and optimized by R&D Systems’ IHC/ICC laboratory for chromogenic IHC experiments using paraffin-embedded tissue samples.

This IHC protocol provides a basic guide for the fixation, microtome sectioning, and staining of paraffin-embedded tissue samples. Each investigator must determine the precise experimental conditions required to generate a strong and specific signal for each antigen of interest. If R&D Systems' primary antibodies are employed, please refer to the product data sheets to obtain the recommended working dilutions. In this protocol, signal visualization is achieved using R&D Systems' Cell and Tissue Staining Kits. For all other reagents, please follow the manufacturer’s instructions.

R&D Systems offers VisUCyte™ HRP Polymer secondary antibodies and staining kits to provide cleaner and faster results. Refer to our Protocol for VisUCyte™ HRP Polymer Detection Reagents for more information.

Please read IHC protocol in its entirety before beginning.

Immunohistochemistry (IHC) Protocol for Fixing and Sectioning Paraffin-embedded Tissue Sections

Reagents Required

  • Formaldehyde Fixative Solution: 85 mM Na2HPO4, 75 mM KH2P04, 4% paraformaldehyde, and 14% (v/v) saturated picric acid, pH 6.9. (Picric acid is optional, enhances preservation of morphology in some tissues)
  • Wash Buffer: 1X PBS (0.145 M NaCl, 0.0027 M KCl, 0.0081 M Na2HPO4, 0.0015 M KH2PO4, pH 7.4)
  • Ethanol: 100%, 90%, 70%
  • Xylene (mixed isomers)
  • Paraffin

Immunohistochemistry Fixing and Sectioning Paraffin-embedded Tissue Sections Protocol

  1. To preserve tissue morphology and retain the antigenicity of the target molecules, fix the tissue by vascular perfusion with 500 - 700 mL of Formaldehyde Fixative Solution.
    • Note: When it is not possible to fix by perfusion, dissected tissue may be fixed by immersion in a 10% formalin solution for 4-8 hours at room temperature. It is commonly accepted that the volume of fixative should be 50 times greater than the size of the immersed tissue. Avoid fixing the tissue for greater than 24 hours since tissue antigens may either be masked or destroyed.
    • Note: R&D Systems scientists perfuse fix all rodent tissue with the exception of lung, spleen, and embryonic tissue, which are immersion fixed.

  2. Because paraffin is immiscible with water, tissue must be dehydrated before adding molten paraffin wax.
    1. Immerse the tissue in 70% ethanol three times for 30 minutes each at room temperature.
    2. Immerse the tissue in 90% ethanol two times for 30 minutes each at room temperature.
    3. Immerse the tissue in 100% ethanol three times for 30 minutes each at room temperature.
    4. Immerse the tissue in xylene (mixed isomers) three times for 20 minutes each at room temperature.

  3. Embed the tissue in paraffin at 58 °C. Tissues can be embedded into paraffin using specialized automated tissue processing systems.

  4. Cut 5 - 15 µm thick tissue sections using a rotary microtome.

  5. Float the sections in a 56 °C water bath.

  6. Mount the sections onto gelatin-coated histological slides. Slides are pre-coated with gelatin to enhance adhesion of the tissue. Please refer to the Protocol for the Preparation of Gelatin-coated Slides for Histological Tissue Sections for instructions on how to prepare gelatin-coated slides.

  7. Dry the slides overnight at room temperature. Slides with paraffin-embedded sections can be stored either at room temperature or in at 2-8 °C for several years in slide storage boxes.

Immunohistochemistry Protocol for Chromogenic Staining of Paraffin-embedded Sections

Reagents Required

Materials

Immunohistochemistry Protocol

This immunohistochemical staining protocol has been developed and optimized for use with R&D Systems Cell and Tissue Staining Kits.

  1. Tissue must be rehydrated before commencing the DAB staining protocol.
    1. Immerse the slides in xylene (mixed isomers) 2 times for 10 minutes each.
    2. Immerse the slides in 100% alcohol 2 times for 10 minutes each.
    3. Immerse the slides in 95% alcohol for 5 minutes.
    4. Immerse the slides in 70% alcohol for 5 minutes.
    5. Immerse the slides in 50% alcohol for 5 minutes.
    6. Rinse the slides with deionized H2O.
    7. Rehydrate the slides with wash buffer for 10 minutes. Drain the excess wash buffer.
      • Note: Excessive fixation may result in the masking of an epitope and strong non-specific background signal that can obscure specific labeling. If necessary, an antigen retrieval protocol can be performed at this time.

  2. Surround the tissue with a hydrophobic barrier using a barrier pen.

  3. To quench endogenous peroxidase activity, incubate the sample with 1-3 drops peroxidase blocking reagent (3% H2O2 in water or methanol) for 5-15 minutes.

  4. Rinse the sample, then gently wash in wash buffer for 5 minutes.

  5. To reduce non-specific hydrophobic interactions between the primary antibodies and the tissue, block the section with 1-3 drops of serum blocking reagent for 15 minutes. Drain the slides and wipe away any excess blocking reagent before proceeding to the next step. Do not rinse.

  6. To block binding to endogenous biotin, incubate the sample with 1-3 drops of avidin blocking reagent for 15 minutes. Rinse the sample with wash buffer, drain slides, and wipe away any excess wash buffer.

  7. To block subsequent binding to the avidin applied in step 6, incubate the sample with 1-3 drops of biotin blocking reagent for 15 minutes. Rinse with wash buffer, drain the slides, and wipe away any excess wash buffer.

  8. Incubate the sample with primary antibodies in Incubation Buffer. Follow manufacturer’s recommendations regarding working dilution for the primary antibody. For chromogenic IHC staining of paraffin-embedded tissue sections using R&D Systems antibodies, it is recommended to incubate overnight at 2-8 °C. This incubation regime allows for optimal specific binding of antibodies to tissue targets and reduces non-specific background staining. These variables may need to be optimized for your system.
    • Note: Appropriate controls are critical for the accurate interpretation of IHC/ICC results. All IHC/ICC experiments should include a negative control using the incubation buffer with no primary antibody to identify non-specific staining of the secondary reagents. Additional controls can be employed to support the specificity of staining generated by the primary antibody. These include absorption controls, (for monoclonal primary antibodies), and tissue type controls.

  9. Rinse the sample with wash buffer. Wash 3 times with wash buffer for 5 minutes and drain the slides.

  10. Incubate the sample with 1-3 drops of biotinylated secondary antibodies for 30-60 minutes, adjusting the incubation time depending on the thickness of the section (approximately 30 minutes for 5-10 µm thick sections and 60 minutes for 10-20 µm thick sections).

  11. Rinse with wash buffer 3 times for 15 minutes each and drain the slides.

  12. Incubate the sample with 1-3 drops of High Sensitivity Streptavidin-HRP conjugate (HSS-HRP) for 30 minutes. This signal amplification technique is referred to as the labeled streptavidin-biotin (LSAB) method.
    • Note: High Sensitivity Streptavidin is a chemical analog of Streptavidin that has little net positive charge at neutral or slightly alkaline pH and will interact only with biotin attached to secondary antibodies. HSS-HRP shows little or no non-specific binding to phospholipids, nucleic acids, and carbohydrate-binding proteins.

  13. Rinse and wash 3 times in wash buffer for 2 minutes each.

  14. Calculate the required working volume of DAB/AEC Chromogen Solution given that 100-200 µL is required to cover the entire tissue section on a single slide. Add 1-5 drops of DAB/AEC Chromogen Solution to cover the entire tissue section and incubate for 3-20 minutes. Monitor the intensity of the tissue staining under a light microscope. Colored precipitate will localize to the sites of antigen expression as the chromogenic substrate is converted by HRP enzyme into insoluble end product.
    • Note: DAB and AEC are hazardous materials. Gloves and safety glasses should be worn and all steps performed inside a fume hood. Please refer to the MSDS for safe deactivation.
    • Note: If required, DAB Enhancer can be used to intensify the DAB Chromogen solution.

  15. Rinse the sample with wash buffer 3 times for 10 minutes each.

  16. Rinse in deionized H2O and drain the slides.

  17. Stained tissue can be mounted either without nuclear counterstaining or counterstained with nuclear counterstain hematoxylin for better visualization of the tissue morphology.

  18. Cover stained tissue with a coverslip of an appropriate size, place slides vertically on filter paper or a towel to drain excess mounting medium, and allow them to dry.
    • Note: Unlike DAB, AEC is soluble in alcohols and xylene. Tissue sections subjected to an HRP-AEC protocol should be coverslipped using only aqueous mounting media.

  19. Visualize staining of tissue under a microscope using a bright-field illumination.
    • Note: Initial IHC/ICC studies often require further optimization and/or additional troubleshooting steps.

Triton is a registered trademark of Dow Chemical.

Related IHC/ICC Resources

IHC/ICC Reagents

Immunohistochemistry (IHC) Protocols
Literature
Product Categories
Protocols